![]() ![]() They show the size and position of the holes as well as board outline and position of connector. has now mechanical drawings for the Pi 4B, Pi 3B+, Pi 3B, Pi 3A+, the Zero (v1.2), the Zero W, Pi 1B+, Pi A+ available. Pi 1 A shares the board layout with the Pi 1 B (suggested by TomG and supported by available pictures). Pi 1 B (rev 1) does not have any mounting holes. See also that describes the existance of drilled holes of 2.9 mm diameter for M2.5 screws. Pi 1 B (rev 2) contains two M2.5 mounting holes (as derived from own measurements, diameter is roughly 2.8 mm). This information is taken from the "Raspberry Pi B+ Mechanical Schematic" (official drawing by J. Pi 1 B+ contains four M2.5 mounting holes - supposedly drilled to 2.75 +/- 0.05 mm. Tl dr: Those models that have holes in the PCB are made for M2.5 (or UNC 3-48) screws and a length fitting to the enclosure or respective counterpart.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |